New experimental insight into the mechanisms of nanoplasticitySKROTZKI, W; ESCHKE, A; JONI, B et al.Acta materialia. 2013, Vol 61, Num 19, pp 7271-7284, issn 1359-6454, 14 p.Article

Effect of cerium and aluminium on the hot-deformation behaviour of magnesiumPRASAD, Braj K; NARAYAN, Sashi P; MODI, Om P et al.International journal of materials research. 2012, Vol 103, Num 5, pp 590-602, issn 1862-5282, 13 p.Article

Plastic anisotropy and associated deformation mechanisms in nanotwinned metalsZESHENG YOU; XIAOYAN LI; LIANGJIN GUI et al.Acta materialia. 2013, Vol 61, Num 1, pp 217-227, issn 1359-6454, 11 p.Article

Material law parameter determination of magnesium alloysEBELING, T; HARTIG, Ch; LASER, T et al.Materials science & engineering. A, Structural materials : properties, microstructure and processing. 2009, Vol 527, Num 1-2, pp 272-280, issn 0921-5093, 9 p.Article

The characteristics of superplastic flow in a magnesium alloy processed by ECAPFIGUEIREDO, Roberto B; LANGDON, Terence G.International journal of materials research. 2009, Vol 100, Num 6, pp 843-846, issn 1862-5282, 4 p.Conference Paper

Deformation behaviour of an Al-6%Cu-0.4%Zr superplastic alloy containing a gradient of textureEDDAHBI, M; RUANO, O. A.Journal of alloys and compounds. 2005, Vol 403, Num 1-2, pp 176-185, issn 0925-8388, 10 p.Article

Structure, deformation and fracture of arc evaporated Zr-Si-N hard filmsYALAMANCHILI, K; FORSEN, R; JIMENEZ-PIQUE, E et al.Surface & coatings technology. 2014, Vol 258, pp 1100-1107, issn 0257-8972, 8 p.Article

High-temperature and low-stress creep anisotropy of single-crystal superalloysJACOME, L. Agudo; NÖRTERSHÄUSER, P; HEYER, J.-K et al.Acta materialia. 2013, Vol 61, Num 8, pp 2926-2943, issn 1359-6454, 18 p.Article

Twinning and martensite in a 304 austenitic stainless steelSHEN, Y. F; LI, X. X; SUN, X et al.Materials science & engineering. A, Structural materials : properties, microstructure and processing. 2012, Vol 552, pp 514-522, issn 0921-5093, 9 p.Article

Tensile properties of electrodeposited nanocrystalline nickelTAI HONG YIM; SEUNG CHAE YOON; HYOUNG SEOP KIM et al.Materials science & engineering. A, Structural materials : properties, microstructure and processing. 2007, Vol 449-451, pp 836-840, issn 0921-5093, 5 p.Conference Paper

Effect of post-rolling after ECAP on deformation behavior of ecaped commercial Al-Mg alloy at 723 KPARK, Kyung-Tae; LEE, Hang-Jae; CHONG SOO LEE et al.Materials science & engineering. A, Structural materials : properties, microstructure and processing. 2005, Vol 393, Num 1-2, pp 118-124, issn 0921-5093, 7 p.Article

Influence of grain size on deformation mechanisms : An extension to nanocrystalline materialsZHU, Yuntian T; LANGDON, Terence G.Materials science & engineering. A, Structural materials : properties, microstructure and processing. 2005, Vol 409, Num 1-2, pp 234-242, issn 0921-5093, 9 p.Article

Mechanical properties of Al(Sc, Zr) alloys at ambient and elevated temperaturesFULLER, Christian B; SEIDMAN, David N; DUNAND, David C et al.Acta materialia. 2003, Vol 51, Num 16, pp 4803-4814, issn 1359-6454, 12 p.Article

Effect of aging treatment on the quasi-static and dynamic compressive properties of aluminum alloy foamsYI FENG; NING TAO; ZHENGANG ZHU et al.Materials letters (General ed.). 2003, Vol 57, Num 24-25, pp 4058-4063, issn 0167-577X, 6 p.Article

Size-dependent deformation mechanisms and strain-rate sensitivity in nanostructured Cu/X (X = Cr, Zr) multilayer filmsNIU, J. J; ZHANG, J. Y; LIU, G et al.Acta materialia. 2012, Vol 60, Num 9, pp 3677-3689, issn 1359-6454, 13 p.Article

Cu/Nb Nanocomposite Wires Processed by Severe Plastic Deformation for Applications in High Pulsed Magnets: Effects of the Multi-Scale Microstructure on the Mechanical PropertiesDUBOIS, J. B; THILLY, L; LECOUTURIER, F et al.IEEE transactions on applied superconductivity. 2012, Vol 22, Num 3, issn 1051-8223, 6900104.1-6900104.4Conference Paper

Deformation and fracture mechanisms in fine- and ultrafine-grained ferrite/martensite dual-phase steels and the effect of agingCALCAGNOTTO, Marion; ADACHI, Yoshitaka; PONGE, Dirk et al.Acta materialia. 2011, Vol 59, Num 2, pp 658-670, issn 1359-6454, 13 p.Article

Deformation mechanisms in yttria-stabilized cubic zirconia single crystalsGALLARDO-LOPEZ, Angela; GOMEZ-GARCIA, Diego; DOMINGUEZ-RODRIGUEZ, Arturo et al.International journal of materials research. 2010, Vol 101, Num 10, pp 1211-1214, issn 1862-5282, 4 p.Conference Paper

Anisotropy of the hot plastic deformation of Ti-6Al-4V single-colony samplesSALEM, A. A; SEMIATIN, S. L.Materials science & engineering. A, Structural materials : properties, microstructure and processing. 2009, Vol 508, Num 1-2, pp 114-120, issn 0921-5093, 7 p.Article

Damage of ductile materials deforming under multiple plastic or viscoplastic mechanismsBESSON, J.International journal of plasticity. 2009, Vol 25, Num 11, pp 2204-2221, issn 0749-6419, 18 p.Article

A study of active deformation systems in titanium alloys: dependence on alloy composition and correlation with deformation textureZAEFFERER, S.Materials science & engineering. A, Structural materials : properties, microstructure and processing. 2003, Vol 344, Num 1-2, pp 20-30, issn 0921-5093, 11 p.Article

Hot workability of as-cast Fe₃Al-2.5%Cr intermetallic alloySUNDAR, R. S; SASTRY, D. H; PRASAD, Y. V. R. K et al.Materials science & engineering. A, Structural materials : properties, microstructure and processing. 2003, Vol 347, Num 1-2, pp 86-92, issn 0921-5093, 7 p.Article

Modelling of the plastic behaviour of III-V compound semiconductors during compressive testsLOHONKA, R; VANDERSCHAEVE, G; KRATOCHVIL, J et al.Materials science & engineering. A, Structural materials : properties, microstructure and processing. 2002, Vol 337, Num 1-2, pp 50-58, issn 0921-5093, 9 p.Article

Deformation mechanisms induced under high cycle fatigue tests in a metastable austenitic stainless steelROA, J. J; FARGAS, G; JIMENEZ-PIQUE, E et al.Materials science & engineering. A, Structural materials : properties, microstructure and processing. 2014, Vol 597, pp 232-236, issn 0921-5093, 5 p.Article

Effect of 110 keV electrons on the deformation mechanisms of low density polyethyleneERMING RUI; JIANQUN YANG; XINGJI LI et al.Polymer degradation and stability. 2014, Vol 109, pp 59-70, issn 0141-3910, 12 p.Article